DG-POD-A Accessories:
Name Qty. Description
Data Flat Cable 1 Connect DG5000 and DG-POG-A.
SMB-to-SMA RF Coaxial Lines 9 Connect the digital logic output with the
device under test.
Logic Analyzer Testing Lines 20 Connect the analog output with the
device under test.
Logic Analyzer Testing Clips 20 Used together with the logic analyzer
testing lines.
Connect DG5000 with DG-POD-A:
When the connection succeeds, if the system detects a digital module, the shortcut
will be automatically switched to “Digital”. To edit digital waveform data, press Utility
Digital “Power On” User*.
Press Protocol in the digital waveform editing interface to select the desired protocol:
RS232, SPI, IIC or PO.
Tip
During digital waveform editing, User* blinking indicates that users need to press
this key again to apply the modified setting to the output.
The following part introduces how to use the operation menu at the front panel of
DG5000 to configure the digital module to realize digital signal output.
DG-POD-A
DG5000
To Next Page
Loading...
