Rigol DG5352

RIGOL
User’s Guide for DG5000
XVIII
Pre-defined Fixed 4 bits Code Pattern ................................................. 5-5
User-defined Code Pattern ................................................................. 5-6
To Set Code Rate .................................................................................... 5-8
IQ Mapping ............................................................................................ 5-9
Chapter 6 Frequency Sweep Output ....................................................... 6-1
To Enable Frequency Sweep .................................................................... 6-2
Start Frequency and End Frequency .......................................................... 6-2
Center Frequency and Frequency Span ..................................................... 6-3
Sweep Type ............................................................................................ 6-4
Linear Sweep ................................................................................... 6-4
Log Sweep ....................................................................................... 6-5
Step Sweep ...................................................................................... 6-6
Sweep Time ........................................................................................... 6-7
Return Time ........................................................................................... 6-7
Mark Frequency ...................................................................................... 6-7
Start Hold ............................................................................................... 6-8
End Hold ................................................................................................ 6-8
Sweep Trigger Source .............................................................................. 6-9
Sweep Trigger Output ............................................................................. 6-10
Chapter 7 Burst Output .......................................................................... 7-1
To Enable Burst Mode .............................................................................. 7-1
Burst Type .............................................................................................. 7-1
N Cycle Burst ................................................................................... 7-1
Infinite Burst .................................................................................... 7-3
Gated Burst...................................................................................... 7-4
Burst Phase ............................................................................................ 7-5
Burst Period ............................................................................................ 7-5
Gated Polarity ......................................................................................... 7-5
Burst Delay............................................................................................. 7-6
Burst Trigger Source ................................................................................ 7-6
Burst Trigger Output ................................................................................ 7-7
Chapter 8 FH Output (Option) ................................................................ 8-1
FH Overview ........................................................................................... 8-2
To Enable FH Function ............................................................................. 8-3
To Select Carrier Waveform ...................................................................... 8-4
FH Switch ............................................................................................... 8-4
w ww. . com
information@itm.com1.800.561.8187