Rigol DG5352

RIGOL Chapter 3 Arbitrary Waveform Output
User’s Guide for DG5000
3-16
use the numeric keyboard to input “0” and select the unit “V” in the pop-up
menu.
2) Press PointID again and use the numeric keyboard or knob to select point 2.
Then press Time and Voltage respectively to define point 2 as 4 μs and 4 V.
3) Define point 3 and point 4 according step 2).
4) After all the points are edited, press OK to return to the upper level menu,
then press Save to enter the file storage interface (refer to “Store and
Recall”) and save the edited waveform.
7. View the edited waveform.
V
μs
4
2
0
-2
4 8 12
2
1
3
4
1
Note: As can be seen from the above figure, the waveform editor will always connect
from the first point to the voltage level of the last point to create a continuous
waveform.
w ww. . com
information@itm.com1.800.561.8187