Rigol DG5352

RIGOL Chapter 3 Arbitrary Waveform Output
User’s Guide for DG5000
3-18
automatically use straight lines to connect the start point (point 2, the level is
4 V) with the stop point (point 4, the level is -2 V) and automatically generate
point 1 and point 3 to create a continuous waveform.
3) After all the points are edited, press Return to return to the upper level menu,
then press Save to enter the file storage interface (refer to “Store and
Recall”) and save the edited waveform.
7. View the edited waveform.
V
μs
4
2
0
-2
4 8 12
2
1
3
4
Note: As can be seen from the above figure, after the start point (point 2) and stop
point (point 4) are inserted numerical values in the current interpolation method, the
waveform editor will automatically generate point 1 and point 3 to create a continuous
waveform.
w ww. . com
information@itm.com1.800.561.8187