Rittal Perforex BC - Panel Machining; Cube Machining; Gantry with Cross-Slide, Spindle, Swarf Extraction and Pressure Plate

3 Product description
Rittal Perforex BC machining centre 17
EN
3.1.8 Panel machining
The clamping serves to store and secure the workpieces to be machined.
Limit stops to position the workpiece are located on the left-hand operating
side as well as in the lower area. After placing the workpiece, the mechani-
cal clamping brackets are applied and clamped.
The spacer bolts are placed in the relevant drill holes of the machine table
as appropriate for the part size.
Fig. 8: Panel clamping – mechanical clamping brackets
Caution: Risk of being crushed!
Fingers might be crushed when applying the clamping brack-
ets.
3.1.9 Cube machining
The cube clamping is located on the right-hand side of the machine. The
cube is placed here and then traversed to the rear either manually or option-
ally with motorised support. The cube is then clamped using the pneumatic
clamping device.
Fig. 9: Cube clamping
3.1.10 Gantry with cross-slide, spindle, swarf extraction and pressure
plate
Gantry (X support):
The moveable machine gantry is vertical and fastened to the machine frame
with linear guides. The complete gantry moves in the X direction via a gear
rack driven by one or more motors fastened to the gantry.