GX-3R Pro Operator’s Manual Chapter 5: User Mode and Calibration • 114
3. Use AIR to display the desired setting.
4. If you selected OFF, press and release POWER MODE to save the setting and return to the
USER PASSWORD item in User Mode.
If you selected ON, continue with Step 5.
5. Press and release POWER MODE. The Set Password Screen appears. The current password
displays and the first digit flashes.
6. Use AIR to display a number from 0 to 9.
7. Press and release POWER MODE to enter the selection and advance to the next number. To
go back a number, press and hold AIR and POWER MODE for a few seconds.
8. Repeat Step 6 and Step 7 to select the remaining numbers. When you press and release
POWER MODE to enter the last number, the password is saved and you return to User Mode.
9. See “Returning to Measuring Mode (START MEASURE)” on page 117 to return to
Measuring Mode.
Viewing the ROM/SUM (ROM/SUM)
The ROM/SUM screen shows the instruments’ firmware version and firmware checksum.
1. While in User Mode, use AIR to place the cursor next to ROM/SUM.
MAINTE 7:49
0405
USER PASSWORD
MAINTE 7:49
USER PASSWORD
ROM / SUM
RADIO STANDARD
USER MODE
To Next Page
Loading...
