GX-3R Pro Operator’s Manual Chapter 5: User Mode and Calibration • 66
3. The screen that appears depends on the setting of User Mode’s USER PASSWORD item.
If USER PASSWORD is set to OFF (factory setting), continue with Step 6.
If USER PASSWORD is set to ON, continue with Step 4.
4. If USER PASSWORD in User Mode is set to ON, a password screen appears and the first
digit flashes.
5. Use AIR to select each password number then press POWER MODE to save it and move on
to the next number. To go back a number, press and hold AIR and POWER MODE for a few
seconds. To reverse the direction of change (ie. from increasing to decreasing or vice versa):
a. Press and hold AIR.
b. Immediately press POWER MODE and then release both buttons.
6. The User Mode menu displays.
7. at the top of the screen indicates that the GX-3R is in User Mode.
8. Use AIR to move through the User Mode menu items.
Tips for Using User Mode
• To scroll from one menu item to the next, press and release AIR. To reverse the scrolling
direction:
a. Press and hold AIR.
b. Immediately press POWER/MODE and then release both buttons.
c. The scrolling direction returns to the original direction when you exit and reenter a menu.
• To skip an item when a question is asked, press and release AIR.
• To enter an item and to save any changes, press and release POWER MODE.
USER PASSWORD
set to
OFF USER PASSWORD
set to
ON
MAINTE 7:49
BUMP TEST
GAS CAL
CAL SETTING
USER MODE
MAINTE 7:49
0000
PASSWORD
MAINTE 7:49
BUMP TEST
GAS CAL
CAL SETTING
USER MODE
To Next Page
Loading...
