GX-3R Pro Operator’s Manual Chapter 4: Display Mode • 52
Station IDs can only be selected in this menu item. You must use the GX-3R Datalogging
Program to edit the 128 station IDs.
1. After entering Display Mode, press and release POWER MODE until STATION ID appears.
2. To change the station ID, press and release AIR. The current station ID flashes.
3. Use AIR to scroll to the desired station ID.
4. Press and release POWER MODE to save the station ID and return to the STATION ID
screen in Display Mode.
Last Successful Calibration Date (CAL DATA)
The CAL DATA screen shows the date of each installed sensors’ last successful calibration. This
screen only appears if CAL REMINDER is set to ON in User Mode.
1. While in Display Mode, press and release POWER MODE until CAL DATA appears.
7:49
S_ID_002
CHANGE : AIR
STATION ID
7:49
S_ID_002
NO : MODE
STATION ID
7:49
YES : AIR
NO : MODE
CAL DATA
To Next Page
Loading...
