GX-3R Pro Operator’s Manual Chapter 6: Maintenance • 132
13. Be sure the gasket along the edge of the rear case is seated correctly. The flat side of the gasket
faces away from the case.
14. Reinstall the rear case to the front case using the screws removed in Step 4.
15. Reinstall the rubber boot, if being used.
16. Turn on the GX-3R Pro.
17. If the instruments goes into a clock failure, set the date/time as described on page 113.
Figure 24: Reinstalling Battery Board Screws
Figure 25: Reinstalling Case Screws
To Next Page
Loading...
