Roche CoaguChek INRange - Beeper Volume

98
CoaguChek INRange User’s Manual
Reminders and Meter Settings
98
Beeper Volume If the beeper is activated, the meter always
beeps when an action is taken, for example a
test strip is inserted or a sufficient sample has
been applied.
The beeper volume can be set or deactivated.
However, in case of an error the meter will
always beep for safety reasons, even if you have
set the beeper function to Off. To set the beeper
v
olume:
1 Select Beeper Volume and press the Enter
button
to open the corresponding menu.
The currently set volume is indicated by a green
dot on the right.
2 Use the up/down arrows button to select
the desired v
olume.
3 Press the Enter button to confirm the
selection, which is now indica
ted by the green
dot.
4 Press the Enter button again to save the
selected v
olume.
6HWWLQJV
%HHSHU9ROXPH
6HW7DUJHWV
5HVXOW)RUPDW
'LVSOD\%ULJKWQHVV
8QLWV
7
LPH'DWH
%HHSHU9ROXPH
0HGLXP
+LJK
2II
/RZ
6DYH