3.19
Transfer of patient profiles to a computer system
Profile transfer
All test values belonging to one patient identification (R see “Entering
a patient/sample identification” in this section) can be transferred to
a computer system en bloc.
The computer must be connected and be ready to receive the data
(R see “Operation with RS 232 C interface” in Section 6).
“TRANSFER PROFILE” is displayed for about 1 second.
Automatically, the current identification is suggested. If necessary, it
can be overwritten or another name can be copied using the “search
and copy” function.
The profile is transferred.
The procedure used for copying a name is the same as that
described for copying results from memory (R see “Calculation of
cardiac risk according to PROCAM”).
Copy the name instead of the test result.
It is also possible to exclude certain test results from the transfer, e.g.
in case of duplicate assays.
For this purpose, label the record concerned by entering “
*
” in posi-
tion 1 of the patient/sample identification and exit with the “ESC” key.
This label can be deleted by keying in “
*
” once again.
The function can be exited at any time by pressing the escape key.
Explanation
Calling up the function
Terminating the input
NA M E ?
A. N . O T HE R
NA M E ?
*. N . O T HE R
Searching and copying
Selective data transfer
Exiting the function
A. N . O T HE R
CH O L 2 4 0 m g / d l
A. N . O T HE R
CH O L 2 4 0 m g / d l
To Next Page
Loading...
Need help?
General
