3.8
Press F10
A record can only be printed out from the risk assessment display.
The instrument asks for a patient identification or suggests an
existing one.
After confirmation, a record showing all the values is printed out.
A record can be transmitted to the computer system in analogy to the
printout of the record (R see “Operation with RS 232 C interface” in
Section 6).
The risk calculator can be exited at any time by pressing “Escape”.
The instrument is then ready to perform a measurement again.
Calculation of cardiac risk according to “FRAMINGHAM”
In the “FRAMINGHAM” study performed in the USA, the incidence of
myocardial infarction in dependence of defined risk factors was
ascertained in 30- to 74-year-old women and men.
Press F2
(See also “Basic instrument settings” in Section 6)
The data are entered as described under “Calculation of cardiac risk
according to PROCAM”.
All the functions described above are available here and are handled
in the same manner.
If a value entered is above or below the limits programmed into the
instrument, Reflotron Plus indicates this by placing the sign “<” or “>”
before the respective maximum or minimum value and performs the
calculation using the programmed limit value.
Printing out a record
Exporting a record
Explanation
Calling up the function
PA T I E N T N A M E ?
A. N . O T HE R
CA R D I A C R I S K
CH O L mg / d l ? > 3 4 0 . 0 0
To Next Page
Loading...