2.6
Printer
Reflotron Plus prints out all
important data:
– results
– error messages
and the message “MEASURE-
MENT INTERRUPTED”!
The procedure for switching off
the printer and altering the
printer settings is described in
Section 2 under “Individual set-
tings” and in Section 6 under
“Basic instrument settings”.
If you do not want to take a
measurement for a longer
period of time, you may put the
Reflotron Plus into standby.
The difference between this and
switching off the instrument
with the on/off switch is that
you save the warm-up time
after restarting the instrument.
For information on setting this
function please refer to “Basic
instrument settings” in
Section 6.
In this setting the green indica-
tor lamp indicates that the
instrument is still switched on.
As soon as you lift up the flap
or enter data via the keyboard
the Reflotron Plus is ready to
perform a measurement again.
Standby function
To Next Page
Loading...