2.35
With the instrument in the
“READY” state press the but-
tons “<” and “>” simultaneously
to call up the menu for indi-
vidual settings.
Use the “<” or “>” button to
position the cursor under
“BEEP” and confirm with “↵”.
Select the desired frequency
(pitch) or “OFF” (no sound sig-
nal) and confirm with “↵”.
Press the buttons “<” and “>”
simultaneously to return the
instrument to the measuring
mode. The Reflotron Plus is
now ready to perform an
analysis again.
See also “Basic instrument
settings” in Section 6.
Note
The sound signal accompany-
ing important system messages
cannot be switched off.
CL O C K P RI N T B E EP
UN I T S S TR I P S D ELE T E
BE E P : O FF F R E Q 1 FR E Q 2
Calling up the menu
Acoustic signal
To Next Page
Loading...
Need help?
General
