3.7
Searching and copying
Result
Changing existing values
The data can also be copied directly from the memory by searching
for the desired value using the keys shown on the left (R see also
“Storage and retrieval of results” in Section 2).
If the test results are not tagged with a patient identification, only the
respective value is displayed.
If the memory contains no further value for the respective para-
meter, Reflotron Plus briefly displays “NO ENTRY” and then returns
to the input prompt.
If a value is found, it may be copied into the input line of the risk
calculator.
After this, the value has to be confirmed once again.
“Search and copy” can be exited at any time
In this example, the incidence is 8.0 % (incidence of infarction in per-
cent over 8 years) and the patient’s risk factor is increased 1.6-fold
compared to people of the same age. The risk (here “++”) may be
from “+” to “+++”. “+” stands for low risk, “++” for moderate risk and
“+++” for high risk.
After the result of the risk assessment has been displayed, various
parameters entered can be searched for and changed using these
two cursor keys.
When you return to the result line, the new risk values are displayed.
The calculation is performed using the Friedewald formula.
The “Home” key takes you directly back to the first input line.
The “End” key takes you directly to the risk assessment display.
A. N . O T HE R
CH O L 24 0 m g /d l
NO E N T R Y
IN C I D . FA C T O R RIS K
8. 0 % 1 . 6 + +
To Next Page
Loading...