Rockwell Automation Publication 1715-UM001J-EN-P - December 2020 271
Appendix C Reconfigure a Module Online
Before the new configuration parameters are sent to the module, you must
make sure that their relationship to each other is in a format the module
accepts and that the values are within the range the module accepts, otherwise
the module can fault or the reconfiguration attempt can fail.
IMPORTANT
Reconfiguring analog modules via ladder logic can be limited to
functions that involve only the changing of values. We do not
recommend that enabling or disabling features be done via
ladder logic. Use the Logix Designer application to enable or
disable these features.
To Next Page
Loading...
Need help?
General
