Rockwell Automation Allen-Bradley Kinetix 5700 - Page 27

Rockwell Automation Publication MOTION-AT007A-EN-P - May 2020 27
Non-regenerative Common DC-bus Configurations With Passive or Active Shunt Chapter 3
Figure 16 - DC-bus Supply with Multiple AC Drives and External Active Shunt
(1) Line reactors are required when three 2198-P208 DC-bus supplies are configured. For line reactor requirements and selection when one or two 2198-P208 DC-bus supplies are configured,
see the Kinetix 5700 Servo Drives User Manual, publication 2198-UM002
.
(2) A DC-bus conditioner module is required to limit DC-bus voltage overshoot at power-on.
(3) Locate the external active shunt close to the DC-bus conditioner. For active shunt wiring and mounting information, see the Kinetix 5700 Servo Drives User Manual, publication 2198-UM002
.
Table 12 - Special Bus Requirements
Drawing Designation Supported Drives Special Bus Requirements
AC drives
PowerFlex 750-Series: Frames 1…6
None
Kinetix 7000: 2099-BM06-S…2099-BM08-S
Kinetix 7000: 2099-BM09-S…2099-BM12-S
(1)
(1) External precharge must be provided if a disconnect between the DC-bus and the drive DC input is used.
Kinetix 6000 and
Kinetix 6200/6500 drives
Kinetix 6000: All 460V configurations
(2)
(2) No internal precharge. Drives must be placed in common-bus follower configuration.
None
Kinetix 6200/6500: All 460V configurations
(2)
2198-P208
2198-CAPMOD-2240
2198-P208
2198-P208
DC+
DC-
M
AC Drive
M
M
M
DC+ DC-
Capacitor
Module
DC-Bus
Power Supply
DC Bus
DC-Bus
Power Supply
DC-Bus
Power Supply
Reactor
Line
Reactor
Line
Reactor
Line
Circuit
Protection
Circuit
Protection
Circuit
Protection
External Active
Shunt
BR
BR1
BR2
DC+
DC-
2198-DCBUSCOND-RP312
DC-bus
Conditioner
Kinetix 6000 or
Kinetix 6200/6500 Drives
M
Integrated
Axis Module
Axis
Modules
AC Line Filter
Three-phase
Three-phase
Source
Contactor
Three-phase
Circuit
Protection
(3)
(2)
(1)
(1)
(1)