236 Rockwell Automation Publication D2-3518-4 - January 2020
Appendix B Using the OIM
Powering Up and Adjusting
the OIM
The first time the OIM is powered up, you are prompted to select a language for
the display text. If the Start-Up routine has not been completed, the Start-Up
menu is displayed immediately following the language selection screen.
On subsequent power ups, if both of these requirements have been met, the Main
Menu is displayed after the initialization screen.
Selecting the Fast Power Up Feature
The fast power up feature bypasses the initialization screen at power up, and the
Main Menu is displayed immediately. To select this feature, select Fast PwrUp
Mode from the Display menu.
Adjusting the Screen Contrast
To adjust the screen contrast, select Contrast from the Display menu.
Resetting the Display
To return all the options for the display to factory-default values, select Reset
Display from the Display menu.
Selecting a Device in the
System
The OIM can access and display data from any active drive or peripheral device
on the network. The drive (port 0) is the default device selected.
To select a device, select the Device Select icon from the Main Menu. The
options listed depend on what is connected to the network.
The name and DPI port number of the device being accessed is shown on the
OIM display (see Figure 94
).
Using the OIM to Program
the Drive
The OIM enables you to view and adjust parameters in the drive or in peripheral
devices connected to the drive. The parameters available for viewing or
adjustment depend on the device selected. See Selecting a Device in the System
on page 236 for information about selecting a device.
The method of viewing and adjusting parameters is the same regardless of the
device selected.
To Next Page
Loading...
