Rockwell Automation Publication D2-3518-4 - January 2020 45
Chapter 4
Mounting The Power Module and Grounding the
Drive
This chapter shows how to mount and properly ground the drive.
Lifting and Mounting the
Drive
Be careful to prevent damage due to dropping or jolting when moving the drive.
A forklift truck or similar means of lifting and transporting may be used. Sling in
a manner that equalizes the load at the lifting points. Use a spreader bar if the
angle of the sling is less than 45 degrees relative to horizontal. Do not jolt while
lifting.
Figure 19 - Lift Point Locations for LiquiFlo 2.0 Drives (Frame 3)
To Next Page
Loading...
