Rockwell Automation Publication D2-3518-4 - January 2020 47
Mounting The Power Module and Grounding the Drive Chapter 4
Lifting and Mounting the
Power Module
Be careful to prevent damage due to dropping or jolting when moving the drive.
A forklift truck or similar means of lifting and transporting may be used. Sling in
a manner that equalizes the load at the lifting points. Use a spreader bar if the
angle of the sling is less than 45 degrees relative to horizontal. Do not jolt while
lifting.
Figure 21 - Lift Point Locations for LiquiFlo 2.0 Power Module (Frame 3)
Figure 22 - Lift Point Locations for LiquiFlo 2.0 Power Module (Frame 4)
Lifting Hole
(both sides)
Lifting Hole
(both sides)
Input and Output
Busbar
Lifting Hole
(both sides)
Lifting Hole
(both sides)
Input and Output
Busbar (both sides)
To Next Page
Loading...
