Rockwell Automation Allen-Bradley LiquiFlo 2.0 - Accessing and Adjusting Parameters

62 Rockwell Automation Publication D2-3518-4 - January 2020
Chapter 8 Programming Basics
Accessing the Parameters
Parameters are programmed and viewed using the OIM or VS Utilities software.
The OIM displays parameters by group, by individual parameter number, and
parameters that have changed from their default value.
To access parameters using the OIM, select the Parameters icon from the main
screen. See Figure 26
.
See Appendix B
for information on modifying parameters using the OIM.
Refer to the VS Utilities Getting Results Manual, publication D2-3488
, for
information on accessing and modifying parameters using VS Utilities software.
Figure 26 - Accessing the Parameters Using the OIM
Viewing Rectifier or Inverter Parameters
The OIM initially displays information about the inverter, including inverter
parameters.
To display rectifier parameters and other information about the rectifier, switch
the OIM to the Active Rectifier device. See Figure 27
.
Stopped Auto
P0: LiquiFlo 2.0
Parameters:
Changed Params
P Numbers
By Group
File:
File 2 Name
File 3 Name
File 1 Name
Monitor Lang
Auto
Stopped
Main Menu
Parameters
P0: LiquiFlo 2.0
Stopped Auto
P0: LiquiFlo 2.0
Parameters:
P Numbers
Changed Params
By Group
Stopped Auto
P0: LiquiFlo 2.0
Parameters:
P Numbers
By Group
Changed Params
Group:
Group 2 Name
Group 3 Name
Group 1 Name
Changed: Par
Searching. . .
Parameter #
Parameter Text
+456.78 Unit
1234
Dflt
Parameter #
Parameter Text
+456.78 Unit
1234
Dflt
ESC/
PROG
ESC/
PROG
ESC/
PROG
ESC/
PROG
ESC/
PROG
ESC/
PROG
ESC/
PROG
ESC/
PROG
>>
>>
>>
>>