Rockwell Automation Allen-Bradley LiquiFlo 2.0 - Page 71

Rockwell Automation Publication D2-3518-4 - January 2020 71
Parameter Descriptions Chapter 9
The RMS output voltage present at terminals T1, T2, and T3 (U, V, and W).
The output power present at T1, T2, and T3 (U, V, and W).
The output power factor.
The accumulated output energy of the drive.
The accumulated time the drive has been outputting power.
The current value of the Motor Operated Potentiometer (MOP) output
frequency value maintained internal to the drive firmware.
7
Output Power
Range: 0...2400.0 kW [0.1 kW]
Default: Read Only
Access: 1 Path: Monitor > Metering
See also:
8
Output Powr Fctr
Range: 0.00...1.00 [0.01]
Default: Read Only
Access: 1 Path: Monitor > Metering
See also:
9
Elapsed MWh
Range: 0.0...429,496,729.5 MWh [0.1 MWh]
Default: Read Only
Access: 1 Path: Monitor > Metering
See also:
10
Elapsed Run Time
Range: 0.0...429,496,729.5 Hr [0.1 Hr]
Default: Read Only
Access: 1 Path: Monitor > Metering
See also:
11
MOP Frequency
Range: +/- 400.0 [0.1 Hz]
Default: Read Only
Access: 1 Path: Monitor > Metering
See also:
12
DC Bus Voltage
Range: 0...3276.7V DC [0.1V DC]
Default: Read Only
Access: 0 Path: Monitor > Metering
See also:
32
32