Overview p-3
!
ATTENTION: Only qualified personnel familiar with
adjustable frequency AC drives and associated machinery should
plan or implement the installation, start-up and subsequent
maintenance of the system. Failure to comply may result in
personal injury and/or equipment damage.
!
ATTENTION: To avoid an electric shock hazard, verify that the
voltage on the bus capacitors has discharged before performing
any work on the drive. Measure the DC bus voltage at the +DC &
–DC terminals of the Power Terminal Block (refer to the
Installation Manual for location). The voltage must be zero.
!
ATTENTION: Risk of injury or equipment damage exists. DPI
host products must not be directly connected together via 1202
cables. Unpredictable behavior can result if two or more devices
are connected in this manner.
To Next Page
Loading...
Need help?
General
