104 Rockwell Automation Publication 750-TG101A-EN-P - June 2022
Chapter 5 Frame 6 Renewal Kits Installation
12. Lift the drive out of the mounting surface, carefully.
13. Remove and discard the drive-side flange gasket.
ATTENTION: To guard against possible personal injury or equipment damage:
• Inspect all lifting hardware for proper attachment before lifting the equipment.
• Do not allow any part of the equipment to contact electrically charged conductors
or components.
• Do not subject the equipment to high rates of acceleration or deceleration while
moving the drive.
• Do not allow personnel or their limbs directly underneath the equipment when
lifting or mounting the drive.
Lifting Hardware Not Shown for Clarity Only
To Next Page
Loading...
Need help?
General
