Rockwell Automation RELIANCE ELECTRIC SP500 - E.3 Wiring Practices; E.3.1 Connecting the AC Mains Filter Output to the SP500 Drive Input

Table E.2 - AC Mains Filter Mounting Dimensions and Weights
AC Mains Filter AC Mains Filter AC Mains Filter AC Mains Filter
Dimension M/N 2DF2282 M/N 2DF4283 M/N 2DF4284 M/N 2DF4285
A 146 mm 217mm 272mm 272mm
5.7" 8.5" 10.7" 10.7
B 407 mm 387mm 441 mm 575 mm
16" 15.25" 17.4" 22.6"
C 382 mm 362 mm 415mm 550 mm
15" 14.25" 16.3" 21.7"
D 104 mm 174mm 230 mm 232 mm
4.1" 6.9" 9.1" 9.1"
E 9mm 9mm 9mm 9mm
0.35" 0.35" 0.35" 0.35"
F 21mm 21.5mm 21mm 20 mm
0.83" 0.85" 0.83" 0.79"
G 63 mm 53 mm 53 mm 93 mm
2.5" 2.1" 2.1" 3.7"
H 118 mm 180 mm 231mm 235 mm
4.6" 7.1" 9.1" 9.1"
J 25mm 18mm 18mm 43 mm
1" 0.71" 0.71" 1.7"
K 22mm 22mm 22mm 28 mm
0.87" 0.87" 0.87" 1.1"
. . 2.5 k 3.2 k 3.2 k 5k
Filter Weight ESI 7 Ib Ib $1 Ib
E.3 Wiring Practices
This section describes how the SP500 drive must be wired to conform to the
standards listed in section E.0. See figures E.2 and E.3 for typical SP500 connection
diagrams.
E.3.1 Connecting the AC Mains Filter Output to the SP500 Drive Input
The power leads that connect the output terminals of the AC Mains Filter to the drive’s
AC input terminals are included with the filter. The flexible conduit to be used with
these power leads is also provided. See figures E.2 and E.3.
* Place the flexible conduit’s hub in the drive’s wire entry hole that is in-line with the
filter’s output wiring opening. Route the leads through the conduit. Secure both ends
of the flexible conduit.
* Trim the power leads to the proper length and connect them to the drive’s AC input
power terminals (R,S, T). Connect the green/yellow ground lead to the drive’s ground
terminal.
Note that the filter’s output leads are red, yellow, and blue. This color coding is
stenciled on the printed circuit board at the filter's input power terminals to help identify
the filter’s output wiring relative to the filter's input wiring.
* When the drive is connected to single-phase AC input power, follow the color coding
shown in figure E.2 and connect all three filter output leads to the drive’s AC input
power terminals.
E-4 SP500 AC Drive Installation and Operation Manual Version 3.1