Rockwell Automation RELIANCE ELECTRIC SP500 - Page 107

* When the drive is connected to three-phase AC input power, the three output leads
from the filter should be connected to the drive’s AC input power terminals as shown
in figure E.3.
* Connect the filter ground wire (green/yellow) to the drive ground.
A B
FILTER’S AG INPUT POWER =———*, } |
“+t O
Tt Te Ts E(GND)
AC MAINS FILTER
GREEN/
REDYELLOW BLUE YELLO
DRIVE’S AC INPUT POWER ————
oo oO
R s T GND
SP500
U Vv Ww GND
oo 9
D>
MOTOR
Figure E.2 - Typical SP500 Single-Phase Connections
A B CG
FILTER’S AG INPUT POWER =——>; } | |
[Ti 2 3 E(GND)
AC MAINS FILTER
GREEN/|
REDYELLOW BLUE YELLO!
“t
DRIVE’S AC INPUT POWER ———
oo O
R s T GND
SP500
U Vv Ww GND
oo 9
D>
MOTOR
Figure E.3 - Typical SP500 Three-Phase Connections
Compliance with Electromagnetic Compatibility Standards E-5