Rockwell Automation Reliance electric SP600 Series - Page 207

Parameter Descriptions 12-77
.
Parameter number whose value will be written from a
communications device data table. Refer to figure 12.47.
Parameters that can be changed only while the drive is stopped
cannot be used as Datalink inputs. Entering a parameter of this type
will disable the link.
Refer to the appropriate communications module manual for more
information about Datalinks.
Parameter number whose value will be written from a
communications device data table. Refer to figure 12.47.
Parameters that can be changed only while the drive is stopped
cannot be used as Datalink inputs. Entering a parameter of this type
will disable the link.
Refer to the appropriate communications module manual for more
information about Datalinks.
304
305
Data In C1 - Link C Word 1
Data In C2 - Link C Word 2
Range: 0 to 387 [1]
Default: 0 (Disabled)
Access: 2 Path: Communication>Datalinks
See also:
306
307
Data In D1 - Link D Word 1
Data In D2 - Link D Word 2
Range: 0 to 387 [1]
Default: 0 (Disabled)
Access: 2 Path: Communication>Datalinks
See also: