Rockwell Automation Reliance electric SP600 Series - Page 273

Parameters Cross-Referenced by Name B-1
APPENDIX B
Parameters
Cross-Referenced
by Name
The following table lists the complete set of SP600 parameters in
alphabetical order.
Parameter Name No. Path (File>Group)
Page
No.
Accel Time 1 140 Dynamic Control>Ramp Rates 12-37
Accel Time 2 141 Dynamic Control>Ramp Rates 12-37
Alarm 1 @ Fault 229 Utility>Diagnostics 12-69
Alarm 2 @ Fault 230 Utility>Diagnostics 12-69
Alarm Config 1 259 Utility>Alarms 12-72
Analog In 1 Hi 322 Inputs & Outputs>Analog Inputs 12-81
Analog In 1 Lo 323 Inputs & Outputs>Analog Inputs 12-82
Analog In 1 Loss 324 Inputs & Outputs>Analog Inputs 12-82
Analog In 2 Hi 325 Inputs & Outputs>Analog Inputs 12-83
Analog In 2 Lo 326 Inputs & Outputs>Analog Inputs 12-83
Analog In 2 Loss 327 Inputs & Outputs>Analog Inputs 12-84
Analog In1 Value 16 Monitor>Metering 12-7
Analog In2 Value 17 Monitor>Metering 12-7
Analog Out1 Hi 343 Inputs & Outputs>Analog Outputs 12-86
Analog Out1 Lo 344 Inputs & Outputs>Analog Outputs 12-86
Analog Out1 Sel 342 Inputs & Outputs>Analog Outputs 12-85
Anlg In Config 320 Inputs & Outputs>Analog Inputs 12-79
Anlg In Sqr Root 321 Inputs & Outputs>Analog Inputs 12-80
Anlg Out Absolut 341 Inputs & Outputs>Analog Outputs 12-85
Auto Rstrt Delay 175 Dynamic Control>Stop/Restart Modes 12-51
Auto Rstrt Tries 174 Dynamic Control>Stop/Restart Modes 12-50
Autotune 61 Motor Control>Torq Attributes 12-15