Rockwell Automation Publication 6200-UM001C-EN-P - July 2018 55
Install Accessories Appendix A
For Non-display VersaView ThinManager Thin Client and Industrial
Computers (cat. nos. 6200T-KB, 6200T-NA, and 6200P-NS3xx)
To install a VESA mounting plate to a non-display VersaView thin client or
industrial computer, perform the following steps.
1. Follow the steps for Pre-configuration
on page 52.
2. With a Torx 10 key or screwdriver, remove the two screws shown below
on the bottom of the non-display thin client or computer.
3. Remove the four screws that secure the factory-installed mounting plate
to the back of the non-display thin client or computer.
4. Install the new backplate supplied with the VESA mounting bracket kit
with the four screws that you removed in step 3.
5. Reinstall the two screws that you removed in step 2.
IMPORTANT To install a VESA mounting kit on the VersaView 5200 ThinManager thin
client single display model (cat. no. 6200T-BA), see the instructions on
page 57
.
To Next Page
Loading...
Need help?
General
