Rohde & Schwarz FSW-K40 - Page 60

Analysis
R&S
®
FSW-K40
60User Manual 1173.9286.02 ─ 15
For more information see Chapter 4.9, "Using Limit Lines", on page 31.
Remote command:
Corner frequencies:
CALCulate:PNLimit:FC5 on page 106
Slope:
CALCulate:PNLimit:SLOPe<segment> on page 108
Copy to User Limit Line
Creates a new user limit line from the data of a phase noise limit line.
The file is stored in the default folder for user limit lines. You can load and edit the limit
line via the "Select Limit Line" dialog box. For more information see "Select Limit Line"
on page 60.
Remote command:
CALCulate:PNLimit:COPY<k> on page 106
6.3.2 Selecting Standard Limit Lines
Access: "Overview" > "Limit Analysis" > "Line Config"
Select Limit Line............................................................................................................60
└ Name.............................................................................................................. 61
└ Unit..................................................................................................................61
└ Compatible......................................................................................................61
└ Visible............................................................................................................. 61
└ Check Traces..................................................................................................61
└ Comment........................................................................................................ 62
└ View Filter....................................................................................................... 62
└ New / Edit / Copy To.......................................................................................62
└ Delete..............................................................................................................62
└ Disable All Lines............................................................................................. 62
Select Limit Line
The "Select Limit Line" dialog box contains functionality to include standard limit lines
in the measurement.
The dialog box consists of a table that shows all available limit lines and their charac-
teristics and a few buttons to manage individual limit lines.
Using Limit Lines