2-6-5. MENU > EVENT > System
In System menu, S.M.A.R.T function monitors
storage conditions such as Temperature,
Conditions, and Recording status.
Storage Full value can be configured so that
the DVR sends notifications when the HDD
usage reaches a certain level. Warning
message can be notified in various ways as
described below.
In S.M.A.R.T Threshold, you can configure tolerable temperature level of the HDD. If the
temperature of HDD increases over the threshold, a notification will be sent in various ways
according to the following settings.
In Alarm tab, the system event can trigger single or multi alarms. Press to select alarms to be
triggered by each event. If Alert is selected, system will pop up a warning message on the screen.
In Notification tab, the system events can be configured to notify single or multi callback sites or
email addresses. Press to enter callback or email addresses to be notified upon system
events.
To Next Page
Loading...