1-4. Tool Panel
1-4-1. DVR Status
DVR tab shows Video Loss, Motion Detection,
Sensor Detection status of the remote site that is
currently connected. User can activate an alarm
remotely in the DVR Status options.
Reload: Refresh to get the latest DVR status
info.
Reset Alarms: Turn off activated Alarms in
the DVR.
Event Pop-up: Activate event pop up option. The
corresponding camera will be displayed in full
screen mode when an event occur. Configure the
duration for the Pop up at Setup > System >
Event Pop-up Duration.
Note
: Event Pop-up will be deactivated even it is
checked if DVR status menu is hidden or other
menu options (e.g. PTZ control) are being used.
1-4-2. PTZ
The second tab of the Tool Panel is PTZ control tab.
In DVR‟s live mode after connection. select the
Channel connected to PTZ camera, and it will
display the site info and activate the PTZ
controllers.
Set Preset: Save PTZ camera‟s current
location as a preset. Up to 16 Presets can be
saved.
Move to Preset: Move PTZ camera to a
saved preset location.
To Next Page
Loading...
General