Regarding the factory settings
lor
the correspondence
between
Program Change Numbers and Patches, refer
to
the
"1. Patch/Program Change Number Correspon-
dence Chart"
I"'"
P.S6).
9.
MIDI
Filter
Accepts setting which determines whelher
or
not,
upon
reception
01
Control Change messages IControl num-
ber:
7)
from
an
external MIDI device, Master Volume will
be
under that control.
[Step 3-9] From the System mode, use ! FUNCTION!
to call up the following parameter Ihave
il
appear
in
the display).
'?t'iIDI
FILTEF:
CC#7
VALUE: RECEIVEIIGNORE
[Step 4-9] Using the i a-Dial!, make the setting.
RECEIVE: Data is received and changes
in
Master
Vol-
ume are made.
IGNORE:
Data received
is
ignored.
• When shipped, the unit was set
\0
"RECEIVE~.
1
O.
Setting
the
Function
of
the
Control
Pedal
Here
set
is
the output mode to
be
used by the GP-16
when the foot controller'S "Control Pedal" is depressed
(when the indicator lights).
[Step 3-10J Fromthe System mode, using
fEUNC;TION"
call up the following parameter (have
it
appear
In
Ihe display)
10.
:::. F'E[:q:!L t'iCiC'E
In order to
make
use of this function, you need to have
an
optionally
available
lootcontrol!er
(FC-1 00
or
FC-1
OOMKU).
11.
Cancellation
of
Output
Select
AllowS for a setting whereby settings for Output Select
made for each patch are cancelled, thus providing output
of
effected sounds from both channels, regardless
01
previous settings. The lunction allows palches to
be
output from the same channel even though their output
channel is different.
[Step
3-11]
FromlheSystemmode,using
!FUNCTIONL
call up the following parameter (have
it
appear in the display).
11
_ DUT
CDIHF:OL
ClUT
CH~
VALUE ENABLE/DISABLE
[Step 4-11] Using the I a-Dial:, make
the
setting.
ENABLE
DISABLE:
Output Select lor each patch
is
enabled.
Output Select for each patch is disabled,
so
effected sounds
are
output from both
channels.
12.
LCD
Contrast
Provides lor adjustment
01
the
display's contrast.
[Step 3-12J FromtheSystemmode,using IFUNCTION:
call
up
the tollowing parameter (have
it
appear
In
the display).
• LCD COIHF.:f:JST
COljTF'f:JST=
I'i
C!
[.1
E = VALUE:
0-100
VALUE MUTE/BYPASS
[Step
4-10J Set the mode using
Ihe
Cl-Dial.
MUTE
BYPASS
Signals
are not output from all oulpullacks
The ongina! guitar sound Input to the GP·16
IS
outputlrom
the specilled output jacks
[Step
4-12J Adjusl Ihe display's contrast
so
thai
the
displayed characters
are
easy
to read, using
the : a-Dial:.
53
t.
..
III
To Next Page
Loading...
Need help?
General
