25
Quick Start
Setup Guide
If you press [ALL SOUND OFF], all sounds being produced are stopped.
6
After your performance, follow the steps in “Turning Off the Power
after the Shutdown Operation” (p. 22) to power the SPD-S off.
Sampling
The SPD-S allows you to load (sample) your favorite sounds, then play them.
The following guides you through the process of connecting a CD player,
sampling a sound from the accompanying CD, and playing it back.
Unauthorized recording (sampling) of any audio work made by any third parties is prohibited by law, unless it
is limited to special circumstances, such as private, personal enjoyment. Do not record illegally.
Roland Corporation assumes no responsibility or liability for legal penalties or claims made by copyright
holders as a result of any illegal recordings made using any Roland product.
■
Before Sampling
Take the following steps before sampling:
1
Turn the INPUT LEVEL knob on the rear panel to MIN.
2
Connect a CD player to the INPUT jacks on the rear panel.
3
Set the MIC/LINE switch on the rear panel to LINE.
4
Power up the CD player.
5
Follow the steps in “Turning On the Power” (p. 22) to power the SPD-S
on.
To prevent malfunction and/
or damage to speakers or other
devices, always turn down the
volume, and turn off the
power on all devices before
making any connections.
SPDS_e.book 25 ページ ２００３年５月３１日 土曜日 午後１０時４３分
To Next Page
Loading...
Need help?
General
