43
Chapter 2 Wave Editing
Chapter 2
Basic Operations for Wave Edit
This section describes the steps for setting wave parameters. Wave settings
are made using Wave Edit.
1
Press [WAVE] so you are in wave mode.
2
Press [-]/[+] to select a wave.
3
Press [EDIT] to go into Wave Edit.
[EDIT] lights at this time.
4
Press PAGE buttons to select an item to be edited from those listed
below, and then press [ENTER].
To select another item after pressing [ENTER], press [EXIT].
For details on each item, see its reference page.
•
WAVE SETUP
-> p. 45
•
START/END POINT
-> p. 47
Listed below are wave utilities. See p. 44.
• WAVE TRUNCATE
• WAVE PITCH
• WAVE CHOP
• WAVE COPY
• WAVE DELETE
• WAVE INFO (Wave Information)
5
Press PAGE buttons to choose the parameter of an item.
6
While pressing [START/STOP] or hitting a pad to monitor the sound,
press [-]/[+] to change the parameter value.
7
Press [EXIT] and then repeat Steps 4 to 6 to continue Wave Edit
operations. Press [WAVE] to finish Wave Edit.
The SPD-S saves the settings (with “now writing..” indicated) and then
returns to the wave mode.
If you hold down [SHIFT] and
press [-]/[+], you can change
the wave number in steps of
10. If you hold down [+] and
press [-], or hold down [-] and
press [+], the wave number
changes quickly.
If you have selected
“I000 OFF” in Step 2 by
mistake, “cannot execute!” is
displayed and you cannot go
into Wave Edit.
When there are any selectable
items, PAGE buttons ([<], [>],
or both) are lit.
When it is necessary to press
[ENTER], it is flashing.
If you have selected an a new
(empty) wave in Step 2, no
items other than WAVE COPY
and WAVE INFO are
indicated.
If you hold down [SHIFT] and
press [FUNC], the parameter is
reset to its initial value.
SPDS_e.book 43 ページ ２００３年５月３１日 土曜日 午後１０時４３分
To Next Page
Loading...
