87
Chapter 7 Changing the Setup (Overall Environment)
Chapter 7
INIT/DELETE
Reset the SPD-S’s settings to initial values, or delete all the data stored in the SPD-S.
If you execute INIT/DELETE to delete patches and waves from the internal memory, the SPD-S will produce no sound.
1.
Set the following parameters. Press [-]/[+] to change the value.
2.
Press [>] to display the screen as shown in the table below. Press [ENTER] to start initialization or
deletion.
During execution, “now processing…” is indicated. After the execution, a “complete!” indication appears, and the SPD-S
returns to the patch mode.
Do not power the SPD-S off during execution.
Parameter Value Descriptions
Init
Del
SETUP,
ALL PATCHES,
ALL WAVES,
ALL
Select the target of initialization or deletion.
SETUP: The setup settings are reset to their initial values.
ALL PATCHES: All patches are deleted.
ALL WAVES: All waves in the SPD-S are deleted.
ALL: The internal memory is initialized. The setup settings are reset to their initial
values and all patches and waves are deleted.
Value selected in Step 1
Screen display
SETUP
init, sure?
ALL PATCHES, ALL WAVES delete, sure?
ALL delete all, sure?
For returning patches/waves to the factory settings, see p. 117.
SPDS_e.book 87 ページ ２００３年５月３１日 土曜日 午後１０時４３分
To Next Page
Loading...
