79
Chapter 7 Changing the Setup (Overall Environment)
Chapter 7
CONTROL SW
Configuring pads for functions other than making sound.
Configuration can be made for individual pad. Hit a pad or press the PAGE buttons while holding down [SHIFT] to change the
pad/trigger/foot switch. You can
verify
the selection with the flashing pad indicators.
* The pad indicator is lit when this parameter is set to anything other than OFF for the corresponding playing surface.
Set the following parameters. Press [-]/[+] to change the value.
When you connect two foot switches using the PCS-31, the white plug of the PCS-31 serves as FOOT SW 1 and the red plug as
FOOT SW 2.
Parameter
Value Descriptions
Ctrl SW
(Control
Switch)
For the pads on
the SPD-S and
external pads:
OFF,
PATCH +,
PATCH -,
TAP TEMPO,
SOUND OFF
For foot switches:
OFF,
PATCH +,
PATCH -,
WAVE SW,
EFCTS SW,
REC-REH,
TAP TEMPO,
SOUND OFF
Select the function to be assigned to a pad on the SPD-S, an external pad, or the foot switch.
PATCH+/PATCH-: Changes the patch.
WAVE SW: Switches between wave A and wave B on the pad for which WAVE SW in
Wave B is set to FOOT SW in Patch Edit.
EFCTS SW: Switches [EFFECTS] on the panel ON and OFF.
REC-REH: Switches among “Standby -> Rec,” “Rec/reh” and “Stop/Play” in Phrase
Maker.
TAP TEMPO: In screens where the tempo is set (such as the Standby screen in Phrase
Maker), this allows you to set the tempo to the timing you demonstrate by
striking a pad or depressing a foot switch.
SOUND OFF: Instantly mutes ALL sounds.
* The selectable functions (values) differ between pads and foot switches.
* No sound is produced if a pad/trigger/foot switch has REC-REH, TAP TEMPO or
SOUND OFF assigned to it.
If you hold down [SHIFT] and press [FUNC], the values for all playing surfaces are changed to OFF.
SPDS_e.book 79 ページ ２００３年５月３１日 土曜日 午後１０時４３分
To Next Page
Loading...
