57
Chapter 3 Sampling
Chapter 3
6
Press [START/STOP] to start sampling.
•When
StartLvl
is set to
OFF
in Step 5
Sampling starts immediately. Start the performance of the device connected
to the INPUT jacks. “Rec” is displayed while sampling is in progress.
•When
StartLvl
is set to
anything other than OFF
in Step 5
“Wait..” appears and the SPD-S enters standby mode. Start the performance
of the device connected to the INPUT jacks. An input signal that is higher in
level than the value set in StartLvl triggers sampling. Alternatively, press
[START/STOP] again to start sampling. “Rec” is displayed while sampling is
in progress.
7
When the performance is finished, press [START/STOP] to finish
sampling.
8
A “write?” indication is displayed and you can name the wave. Press
the PAGE buttons to move the cursor under the name characters and
press [-]/[+] to change them. When the name is complete, press
[ENTER] to save it.
A “now writing..” indication appears until the wave is saved.
If you do not want to save the wave, press [EXIT], and you will return to the “Stby” (Standby)
screen in Step 4.
9
A “continue?” indication appears. Then, by pressing [ENTER], you can
continue sampling with the parameter values retained as specified in
Step 5. Press [EXIT] to return to the wave mode.
Do not power the SPD-S off
while sampling is in progress.
If you press [START/STOP] or
hit a pad, you can listen the
sampled sound.
Do not power the SPD-S off
while saving a wave.
SPDS_e.book 57 ページ ２００３年５月３１日 土曜日 午後１０時４３分
To Next Page
Loading...
Need help?
General
