Roland VersaStudio BT-12 - Network Configuration and Management

Usingthe[System]Menu
123

Normally, select [Auto Detect]. When printing is performed on fabrics of varied
thicknessesoraverticalaberrationorblurringoccurs,select[Always].
• AutoDetect
• Always
Default:[AutoDetect]
ImgRecov.Error
Youcanspecifywhetherornot[PageRecoveryError]isreported.
• Display
• DonotDisplay
Default:[Display]
DisplayJobName
Thenameofthejobisdisplayedonthescreenfromwhenthejobistransmitteduntil
the[Start]keyispressed.
• On
• Off
Default:[Off]
DisplayVersion
Displaysthefirmwareversion.
PrinterVersion
Displaysthefirmwareversionofthemachine.
InkC.U.Space
Youcanchecktheremainingcapacityoftheinkcollectorunit.
Changingthe[System]Menu
ThefollowingprocedureisanexampleofsettingtheEnergySavermode.
1.
Pressthe[ /Menu]key.
2.
Press[]or[/Menu]keytodisplay[System],andthenpressthe[#Enter]key.

3.
Press[]or[/Menu]keytodisplay[EnergySaver],andthenpressthe[#Enter]
key.

4.
Pressthe[#Enter]key.
<System>
EnergySaver
<Menu>
System