Roland VersaStudio BT-12 - Ink Collector Unit Almost Full; Ink Collector Unit Full; Used Ink Collector Unit; Out of Printable Temperature Range

214
9.Troubleshooting

InkCollectorUnitAlmostFull
Theinkcollectorunitisalmostfull.
Haveanewinkcollectorunithandy.

• Ifaninkcartridgestartsrunningoutofinkwhentheinkcollectorunitisalmostfull,thealert
indicatorwillflashandamessageinformingyouofthecartridge'slowinklevelwillappearon
thedisplay.
InkCollectorUnitFull
Theinkcollectorunitisfull.
Replacetheinkcollectorunit.
Seepage166"ReplacinganInkCollectorUnit".
UsedInkCollectorUnit
Ausedinkcollectorunitisinstalled.
Replacetheinkcollectorunit.
Seepage166"ReplacinganInkCollectorUnit".
OutofPrintableTemperatureRange
Printingisnotpossiblebecausetheprinterisplacedinalocationthatistoohotorcold.
Movethemachinetoamoresuitableenvironment.
1.
Pressandholddownthe[Power]keyforonesecond.
2.
Placethemachineinanenvironmentwhereatemperaturerangeisbetween10
and40°C(50and104°F).
3.
Turnthemachineon.

• Evenafterthepoweristurnedon,themachinemayremaininstandbymodeuntilit
acclimatestotheroomtemperature.Ifthishappens,waituntilthepowerlampstops
flashingandstayslit.
• Fordetailsaboutwhatconditionsthemachinecanbeusedunder(ambienttemperatureand
humidityrange),seepage24"CheckingtheComputerandInstallationArea"