Roland VersaStudio BT-12 - Positions Do Not Match the Displayed Image; Other Problems

200
9.Troubleshooting

Doesthefabric(garment)typesettingmatch?
Makesurethatthefabric(garment)typesettingoftheDesignSoftwareortheprinterdriver
matchesthetypeoffabric(garment)loaded.
Seepage84"Printing".
PositionsDoNotMatchtheDisplayedImage
Ifthepositionofprinteditemsdiffersfromthepositionofdisplayeditems,refertothefollowing
questions:
Havethesettingsforpagelayoutbeenmade?
Checkwhetherpagelayoutsettingshavebeenmadewiththeapplication.
Doesthetraysizesettingmatch?
Makesurethatthetraysizeselectedinthe[PrintOn:]listofthe[PrintingPreferences]dialogbox
matchesthesizeofthetrayloaded.
Havetheprintheadsbeenaligned?
When bidirectional printing isperformed, select [Head Position] to align the printheads. If the
problempersists,printthenozzlechecktestpatternandcleantheprintheadsasnecessary.
Seepage104"HeadPosition",page99"NozzleCheck"andpage101"Head‐cleaning".
Isthefabriccorrectlyloaded?
Putmarksforpositioningusingthesuppliedprotectioncover,andthenloadthefabricsothatthe
marksmatchthecornersofthetable.
Seepage58"LoadingFabrics".
Haveyouchangedprintquality?
Whenprintingonfabricsofvariedthicknessesoryouareconcernedwithpositionaberrationor
imageblurring,tryunidirectionalprintingtoimproveprintquality.
In[PrintQuality]onthe[DetailedSettings]tab,selectthe[Uni‐directionalprintonly]checkbox.
Note,however,thatthiswillslowprintingdown.
OtherProblems
Youmayeliminatecertainproblemsbychangingtheprinterdriversettingsasdescribedbelow:
Cannotprintcertaindataproperlywhenusingacertainapplication,orcannotprintimage
dataproperly.
• Inthe[SelectPrintQuality:],select[Vivid].If[Vivid]cannotbeselected,select[Fine].
• Onthe[DetailedSettings]tab,select[DriverOptions],andthenselectthe[SpoolDatainEMF
Format]checkbox.
• Onthe[DetailedSettings]tab,select[PrintQuality],andthenclearthe[AdjustPhotographs]
and[SmoothLowResolutionImages]checkboxes.
• Onthe[DetailedSettings]tab,select[PrintQuality],andthenselectthe[ChangeData
Processing]checkbox.