Roland VersaStudio BT-12 - 2. Preparing for Printing; Initial Setup and Environment Checks

LoadingandRemovingtheTray
21
DSA063

RemovingtheTray
Afterprintingiscompleted,removethetrayonceitreturnsandstopsatthepositionsothatyou
canseethetraypositioninglineontheleftsideofthetray.
Whenthe[Start]keyislitup,printinghasnotyetcompleted.Pressthe[Start]keyagainwithout
removingormovingthetrayfromthemachine.Printingstartsagain.


WhenusingtheA4standardtrayorA5tray,inserttheprotectioncoverhorizontallyasillustrated
inthefigure,andthenremoveitwiththeA4standardtrayorA5tray.Thispreventsyoufrom
comingintocontactwiththeprintingsurface.Makesuretheprotectioncoveriscorrectly
positionedhorizontally.
DYX008

