Roland VersaStudio BT-12 - Changing the [Host Interface] Menu

5.MachineSetupMenus
128

USBSetting
Youcanspecifythesettingsrelatedtocommunicationwhenthecomputerandmachineare
connectedviaUSB.Usually,youdonotneedtochangethesesettings.
Afterchangingthissetting,turnthemachineoff,andthenturnitonagain.
USBSpeed
• FullSpeed
• Auto
Default:[Auto]
PortSetting
• On
• Off
Default:[Off]
Changingthe[HostInterface]Menu
Thissectiongivesanexampleofchangingasettinginthe[HostInterface]menu.
1.
Pressthe[ /Menu]key.
2.
Pressthe[ ]or[ /Menu]keytodisplay[HostInterface],andthenpressthe
[#Enter]key.

3.
Pressthe[ ]or[ /Menu]keytodisplay[I/OTimeout],andthenpressthe
[#Enter]key.

4.
Pressthe[ ]or[ /Menu]keytodisplay[20seconds],andthenpressthe
[#Enter]key.

5.
Pressthe[Escape]key.
<I/OTimeout>
20seconds
<HostInterface>
I/OTimeout
<Menu>
HostInterface