Roland VersaStudio BT-12 - Filter Replacement and Cleaning Procedures

168
8.Maintenance





• Whenremovingtheinkcollectorunit,donottouchtheinsideofthemachine.
• Donotuseaninkcollectorunitthathasnotbeenusedforalongtime.
• Donottouchtheinkcollectorunit'chipcontacts.
• Takecarenottodroptheinkcollectorunit.
• Takecarenottodroptheinkcollectorunitwhenputtingitinthesuppliedplasticbag.The
bagmighttear,causinginktospill.
• Makesuretheinkcollectorunitisfullyinserted.Ifitisnot,inkwillleakinsidethemachine.
1.
Taketheinkcollectorunitoutofthebox.
2.
Opentherightfrontcover.
DYX030

3.
Waitatleastfiveseconds,andthenremovethefullinkcollectorunitfromthe
machine.
DSA322
1
1
2

Whilepullingtheunitout,keeptheunitlevelandpressontheareamarked"PUSH".
• Whenremovingtheinkcartridge,avoidputtingyourhandneartheplacewheretheink
cartridgeisinstalled.Ifinkcomesincontactwithyourhands,washthemthoroughlywith
soapandwater.
• Whenreplacingink,avoidgettinginkonyourskin.Ifinkcomesintocontactwithyour
skin,washtheaffectedareathoroughlywithsoapandwater.