Configuration
EVQM-V01-R6 Installation and Operation Manual Quantum Intelligent EV Charging Pedestal
December 2023 Page 36 of 52
IMPORTANT: INSTALLERS
1. Make sure you pass this manual to the charge point owner.
2. Make sure you pass the Installation Certificate (and any associated paperwork)
to the charge point owner.
3. Make sure you pass the Configuration Tag to the charge point owner.
x Place the removeable QR code label from the Configuration tag into the
space provided on the REAR of this manual.
x Alternatively, the label may be placed on to the Fuse/Consumer unit that
feeds the charge point, or on the installation certificate.
x As a back-up, write the charge point ID/Serial number and the password
in the spaces below:
For Example Rolec_A
B
C
1
2
3
4
5
x Passwords may use special characters, numbers, and upper and lower-
case letters. Enter the password exactly as shown on the label.
ID/Serial
Rolec_
Password
Use the additional fields below if you have a 4-way unit.
ID/Serial
Rolec_
Password
NOTE: 4-Way Quantum: The 4-way Quantum is effectively 2x 2-way chargers within 1
pedestal and each of these chargers has a Configuration Tag that shows an ID such as
Rolec_DKA12345.
The ID and password of each charger is required for configuration/pairing with Monta.
Please make a record of them in the fields above
15. Now refer to Monta Connections on page 39 that describes connecting to the
Monta App.
To Next Page
Loading...
Need help?
General