Rosemount Model 3095 Multivariable Level Controller
A-12
Message Description
There is unsent data.
Send it before shutting
off?
Press YES to send unsent data and turn the HC off. Press NO to
turn the HC off and lose the unsent data.
Too few data bytes
received
Command returns fewer data bytes than expected as determined
by the device description.
Transmitter Fault Device returns a command response indicating a fault with the
connected device.
Units for <variable
parameter> has changed.
Unit must be sent before
editing, or invalid data
will be sent.
The engineering units for this variable have been edited. Send
engineering units to the device before editing this variable.
Unsent data to online
device. SEND or LOSE
data
There is unsent data for a previously connected device which
must be sent or thrown away before connecting to another device.
Use up/down arrows to
change contrast. Press
DONE when done.
Gives direction to change the contrast of the HC display.
Value out of range
The user-entered value is either not within the range for the given
type and size of variable or not within the min/max specified by the
device.
<message> occurred
reading/writing <variable
parameter>
Either a read/write command indicates too few data bytes
received, transmitter fault, invalid response code, invalid response
command, invalid reply data field, or failed pre- or post-read
method; or a response code of any class other than SUCCESS is
returned reading a particular variable.
<variable parameter> has
an unknown value. Unit
must be sent before
editing, or invalid data will
be sent.
A variable related to this variable has been edited. Send related
variable to the device before editing this variable.
To Next Page
Loading...
