Rosslare AYC-Q60 - Page 59

Controller Functionality
AYC-E/Q/T60 Family Installation and Programming Manual 59
If the selected slot already has a
Primary code but no Secondary
code, the Mode LED flashes red,
indicating that the controller is
ready to accept a Secondary
code.
If the selected slot already has a
Primary and Secondary code
, you
hear a long beep and the
controller returns to Normal
mode.
4. Perform one of the following:
 Enter the PIN code that you
want to assign as the
Primary or Secondary code
for this slot number.
 Present your user card that you want to assign as the Primary
or Secondary code for this slot number.
If the PIN or user card presented is valid, the Mode LED stops
flashing and the controller is ready for you to enter the next 3-
digit slot number (refer to Step 3) for the slot to which you want
to assign a code.
5. Do one of the following:
 Press # to move to the next slot number.
 If you do not wish to continue enrolling codes, press # twice
and the controller returns to Normal mode.
Mode/Transmit
Door/Program
Red
Orange
Mode/Transmit
Door/Program
Green