Rotec VersaTech 600 ULB - Installation; Power Supply

2.1 INSTALLATION
12 DOC01-V6ULB+
2 INSTALLATION
2.1 Power supply
At any time, the main voltage on the device can be safely removed by disconnecting the
power cable from the device connected to the wall socket provided for this purpose.
Ensure that the power cable is accessible at all times.
Please note that this is a Class I device and must be plugged into an earthed socket.
POWER SUPPLY WARNINGS
 Connecting the device to an ungrounded power supply increases the RISK OF
ELECTRIC SHOCK;
 After a significant accidental liquid spill on electronic components, cables and/or
motors. The operation of these components may be affected. Immediately
unplug the bed, remove the user from the bed, clean and have the bed inspected
by qualified technicians. Failure to follow these safety instructions could
jeopardize the integrity of the bed and result in SERIOUS INJURY. The bed can
only be put back into service if it has been properly cleaned and inspected;
 TO AVOID INJURY AND/OR BREAKAGE, ENSURE THAT the power cable is not in
a position where it could be damaged during use of the bed;