Rotec VersaTech 600 ULB - Replacing a Bed Wheel

To Next Page

To Previous Page

6.8 REPAIR PROCEDURES

52 DOC01-V6ULB+

6.8 Replacing a bed wheel

Tools required :

• 9/16" wrench • 1/2" wrench • Extractor screwdriver

• Allen key #3 • Allen key #4 • Allen key #5

• Candle (2) • Hammer

Procedure:

1. Raise the bed to its highest position.

2. Set brake pedal to neutral position.

3. Place jack stand on the side of the defective wheel.

4. Lower the bed onto the jack stand so that the wheel no longer touches the

ground.