R5 SOLID AIS System
OPERATION
7000 118-200, C2 Page 31
4.3.1 Navigating in Menus
Use the ARROW KEYPAD buttons < > and ∧ ∨ to navigate between the view buttons
in the different menus. Press the ENTER button to enter the currently selected view. It
is also possible to directly select a view by pressing the ALPHANUMERIC KEY that
corresponds to the number in the upper left corner of the view button.
Figure 11 – Main Menu
4.4 Configuration Parameters
This section describes the different configuration parameters that can be set in the R5
SOLID. Some of the parameters will only be available when operating in “Class A” mode;
these parameters are marked with blue color. Parameters that are only available when
operating in “Inland” mode are marked with red color. Common parameters for both
system modes are white.
4.4.1 Main Menu Voyage AIS Voyage
The parameters in AIS Voyage view are used for input of voyage specific information
that is sent over the AIS link. These parameters should typically be configured before
each voyage.
When the R5 SOLID system mode is set to “Inland”, additional voyage parameters for
inland water way voyages are available. The system mode can be configured in the
System Settings view described in section 4.4.16.
Changes the navigational status reported by own ship.
It is also possible to quickly change navigational status
by pressing the OPT button when standing in the Main
Menu.
The vertical distance measured from the lowest point of
a ship’s hull to the water surface, in meters (one
decimal precision)
To Next Page
Loading...
